JP AR15 Trigger Spring Kit
JP Trigger and Hammer Spring Sets - spending $140 or more for trigger parts on every AR15 rifle you may own may not be realistic. If you can't quite pop for our complete trigger kit, or have too many rifles and can't justify expensive triggers in all of them, then this may be for you. You can achieve a significant improvement in your AR actions by using a set of JP custom trigger/hammer springs. With proper sear and hammer notch preparation, a good 4.5 to 5.0 smooth trigger in a rifle with standard trigger components is possible. It will not have the extremely short engagement/over travel feel like the JP trigger, but you will have a smooth "roll-off" feel that will give usable trigger control. The spring kit includes trigger, hammer and disconnector spring and complete instructions on how to prep your parts for best results.
Note: Use of this spring kit requires the use of US manufactured (domestic) ammunition or reloads with domestic (non-NATO spec) primers as ignition reliability will be reduced with hard low sensitivity primers as found in made foreign made ammunitions and NATO specification ammunition. Use these parts only in rifles for recreational or competition shooting. Do not use this spring kit for any defense or duty applications or any AR-10 type rifle. Order the JPFC-1T or JPFCP-1T for AR-10, duty or defense applications.
The following spring sets are available:
JPS3.5 - Reduced power spring kit, yields about 4 to 4.5 lb pull with standard AR-15 trigger parts and 3.0 to 3.5 lbs with JP trigger parts.
JPS3.5T - Tactical Reliability Enhanced Spring Kit, 3.5 - 4.0 pound trigger pull with JP fire control parts. This kit includes the Yellow Trigger Spring, Red Hammer Spring, and Disconnector spring. To be used only with JP trigger parts. Will not yield substantial change on standard AR-15 trigger components.
JPS4.0 - Duty Spring Kit, 4.0 - 4.5 pound trigger pull with JP fire control parts. To be used only with JP trigger parts. Will not yield substantial change on standard AR-15 trigger components.
JPS4.5 - CMP Service Rifle Spring Kit, 4.5-lb trigger pull when used with JP trigger components. To be used only with JP trigger parts. Will not yield substantial change on standard AR-15 trigger components. In stock and ready to ship.